Salta al contenuto principale

Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement

Cosa ti serve

  1. Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement, Rear and Side Case: passo 1, immagine 1 di 1
    • Use tweezers to completely remove the sticker from the rear of controller.

  2. Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement: passo 2, immagine 1 di 1
    • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

  3. Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement: passo 3, immagine 1 di 2 Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement: passo 3, immagine 2 di 2
    • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

    • Use the plastic opening tool to pry the two cases apart.

  4. Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement: passo 4, immagine 1 di 2 Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement: passo 4, immagine 2 di 2
    • Remove the two rubber side grips.

  5. Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement, RS-DP-LS Switch: passo 5, immagine 1 di 2 Mad Catz Street Fighter IV FightPad RS-DP-LS Switch Replacement, RS-DP-LS Switch: passo 5, immagine 2 di 2
    • Locate RS-DP-LS switch.

    • Pull upwards on the switch to remove it.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Jefferson Hsu

Membro da: 09/18/12

411 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 1-7, Propen Fall 2012 Membro di Cal Poly, Team 1-7, Propen Fall 2012

CPSU-PROPEN-F12S1G7

4 Membri

14 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 1,448