Aggiusta la tua roba Comunità Store

MacBook Pro 17" Unibody Lower Case Replacement

Introduzione

Remove the lower case to access most components in your MacBook Pro 17" Unibody.

Cosa ti serve

  1. MacBook Pro 17" Unibody Lower Case Replacement, Lower Case: passo 1, immagine 1 di 1

    • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm Phillips screws.

    • Seven 3 mm Phillips screws.

    Modifica

  3. MacBook Pro 17" Unibody Lower Case Replacement: passo 2, immagine 1 di 2 MacBook Pro 17" Unibody Lower Case Replacement: passo 2, immagine 2 di 2

    • Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case.

    • During reassembly, carefully align the lower case and then press it firmly until both clips engage.

    • Remove the lower case.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 19 persone hanno completato questa guida.

Un commento

Is there a DIY on replacing the rubber feet?

retrotechpost - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 37

Tutti i Tempi: 17,862