Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Con il case chiuso, posizionare l'Unibody capovolto su una superficie piatta.
-
Premere il lato scanalato della chiusura di sgancio dello sportello di accesso, affinché sia possibile prendere l'estremità libera con le mani. Sollevare la chiusura di sgancio finché non è in posizione verticale.
-
-
-
Afferra la linguetta di plastica trasparente e tira la batteria verso l'alto per rimuoverla dall'Unibody.
-
Premendo la chiusura, questa bloccherà la batteria in posizione.
-
-
-
Rimuovere le otto viti seguenti, che fissano il case inferiore al case:
-
Una vite con testa a croce da 5,4 mm.
-
Tre viti con testa a croce da 14 mm.
-
Quattro viti con testa a croce da 3,5 mm.
-
-
-
Scollega il cavo della fotocamera estraendo il terminale maschio dalla sua presa.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the flat end of a spudger, pry the subwoofer connector straight up off the logic board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the following four screws securing the subwoofer and right speaker to the upper case:
-
Two 3.2 mm Phillips screws.
-
One 2.6 mm Phillips screw.
-
One 5 mm Phillips screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the subwoofer and right speaker assembly out of the upper case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the single Phillips screw securing the hard drive bracket to the upper case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the hard drive by its plastic pull tab and remove the freed hard drive bracket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the hard drive out of its supports and disconnect the SATA cable by pulling the connector straight away from the hard drive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the following 5 screws securing the mid wall to the upper case:
-
Three 10.5 mm Phillips screws.
-
Two 3.7 mm Phillips screws.
-
Lift the mid wall out of the upper case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to pry the hard drive cable connector straight up off the logic board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel the hard drive cable from the adhesive securing it to the upper case, and maneuver the plastic retaining block out of the upper case.
-
Annulla: non ho completato questa guida.
Altre 9 persone hanno completato questa guida.
Un commento
great explanation I was looking for instruction on YouTube but with no luck thank you so much !!!