Aggiusta la tua roba Comunità Store

MacBook Pro 15" Unibody Early 2011 Lower Case Replacement

Introduzione

Remove the lower case to access most of your MacBook Pro's internals.

Cosa ti serve

  1. MacBook Pro 15" Unibody Early 2011 Lower Case Replacement, Lower Case: passo 1, immagine 1 di 1

    • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm (14.1 mm) Phillips screws.

    • Seven 3 mm Phillips screws.

    • When removing these screws, note how they come out at a slight angle. They must be reinstalled the same way.

    Traduci

  3. MacBook Pro 15" Unibody Early 2011 Lower Case Replacement: passo 2, immagine 1 di 1

    • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

    • Remove the lower case and set it aside.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 37 persone hanno completato questa guida.

2 Commenti

For re-assembly, tilt the screw driver slightly at an angle tangent to the case's edge when screwing in the seven 3 mm Phillips screws. Screw the 13 mm screws directly downward. This should ensure better thread engagement.

Matthew Adler - Replica

Another method for insuring screws end up on the right thread is to turn the screw in reverse (anti-clockwise) to begin with until you feel a click, then you'll know the screw has fallen into the thread correctly and you can drive it home clockwise.

John Ward - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 13

Ultimi 30 Giorni: 55

Tutti i Tempi: 28,839