MacBook Pro 15" Retina Display Mid 2015 AirPort Board Replacement

Passo 1 Lower Case

• Remove the following P5 pentalobe screws securing the lower case to the MacBook Pro:
• Eight 3.1 mm
• Two 2.3 mm
Traduci
24 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 2



• Lifting from the edge nearest the clutch cover, lift the lower case off the MacBook Pro.
Traduci
3 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 3
• The lower case has two plastic pegs (red) that fit into plastic clips in the upper case (orange).
• During reassembly, gently push down the center of the lower case to reattach the case to its two plastic clips.
Traduci
6 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 4 Battery Connector
• Peel back the sticker covering the battery connector.
Traduci
7 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 5
• Gently lift each side of the battery connector to pry the connector out of its socket on the logic board.
• Bend the connector back toward the battery, ensuring that the battery connector doesn't accidentally make contact with the logic board.
Traduci
20 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 6 AirPort Board
• Disconnect the three airport Antenna cable connectors from their sockets on the AirPort board and bend them up and out of the way.
• Be careful to pry only against each connector, and not its cable or socket.
Traduci
Aggiungi un commento
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 7
• Remove the single 2.9 mm T5 Torx screw securing the AirPort board.
Traduci
Un commento
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 8
• Lift the end of the AirPort board up enough to pass over the heat sink directly behind it.
• Do not lift the AirPort board too high, or you could damage the contacts or socket.
• Pull the AirPort board straight out of its socket on the logic board.
• There is a slightly adhesive thermal pad beneath the AirPort board. Be sure to reapply this when reinstalling the board, or transfer it to your replacement board.
Traduci
Aggiungi un commento
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento

Autore

con 4 altri collaboratori

Andrew Optimus Goldheart

Membro da: 10/17/09

502.807 Reputazione

407 Guide realizzate

Distintivi: 44

• 
• 
• 

+41 altri distintivi

Team

iFixit Membro di iFixit

Staff

135 Membri

16.767 Guide realizzate

Incorpora questa guida

Scegli una dimensione e copia il codice qui sotto per incorporare questa guida come un piccolo widget sul tuo sito/forum.

Anteprima