Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

Remove the lower case to access the internal components of your MacBook Pro.

  1. Remove the following ten screws:
    • Remove the following ten screws:

    • Three 14.4 mm Phillips #00 screws

    • Three 3.5 mm Phillips #00 screws

    • Four 3.5 mm shouldered Phillips #00 screws

    • When replacing the small screws, align them perpendicular to the slight curvature of the case (they don't go straight down).

  2. OPEN ALL THE TABS

    RAM Upgrade Kits for Mac

    Acquista Kit

    Enough RAM
    For All The Tabs

    Acquista Kit
  3. Use your fingers to pry the lower case away from the body of the MacBook near the vent. Remove the lower case.
    • Use your fingers to pry the lower case away from the body of the MacBook near the vent.

    • Remove the lower case.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 75 persone hanno completato questa guida.

Team

iFixit Membro di iFixit

Community

130 Membri

12.412 Guide realizzate

When purchasing a new bottom panel, do any of the stickers or pads have to be transferred to the new part? How?

Matthew Parrott - Replica

This is the instructions on how to just remove the bottom cover to access other components. The part is sold here on iFixit for $99 and looks to include the rubber feet.

Cwoodyard -

Where can I get a new backover?

SkyGamer - Replica

The back cover is sold here and can be found at the top of the page.

Cwoodyard -

Can i buy this bottom replacement piece here or is this instructions on how to do it?

itsRadioBiz - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 20

Ultimi 7 Giorni: 120

Ultimi 30 Giorni: 522

Tutti i Tempi: 51,782