Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
For this step, it is recommended to use a heat gun or hair dryer to soften the adhesive securing the microphone assembly to the upper case. You may be able to remove it without doing so, but will risk damaging the microphone cable.
-
With the heat gun set to low, heat the microphone assembly to loosen the adhesive attaching it to the upper case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Tweezers$4.99-
Use the tip of a spudger to remove the piece of tape covering one of two microphones.
-
Grasp the piece of tape with a pair of tweezers and remove it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Repeat the same procedure as the previous step to remove the tape covering the second microphone.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wedge the tip of a spudger underneath the microphone assembly cable.
-
Run the spudger up along the bottom of the microphone assembly cable to separate it from the upper case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently wedge the tip of a spudger underneath the second microphone and push inwards to loosen the adhesive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pry the first microphone up off the upper case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift and remove the microphone assembly out of the upper case.
-