Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Attrezzo utilizzato in questo passaggio:Magnetic Project Mat$19.95
-
Rimuovi le 10 viti seguenti che fissano il coperchio inferiore al case superiore:
-
Due viti Pentalobe da 2,3 mm
-
Otto viti Pentalobe da 3,0 mm
-
-
-
Rimuovi la copertura in plastica attaccata alla scheda dei contatti della batteria.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the single 2.7 mm T5 Torx screw securing the AirPort board to the I/O board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger to pry and disconnect the three antenna cable connectors from the AirPort board.
-
Connect the long-sleeved cable to the center socket.
-
The short-sleeved cable connects next to the screw.
-
The remaining cable has no sleeve, and connects in the last empty socket, next to the fan.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Move the antenna cables aside, clear of the AirPort board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wedge a plastic opening tool between the AirPort board (side nearest the I/O ports) and the I/O board.
-
Gently pry the AirPort board upwards, but do not remove it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the AirPort board straight out of its socket on the I/O board.
-
Annulla: non ho completato questa guida.
Altre 17 persone hanno completato questa guida.