Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Attrezzo utilizzato in questo passaggio:Magnetic Project Mat$19.95
-
Rimuovi le 10 viti seguenti che fissano il coperchio inferiore al case superiore:
-
Due viti Pentalobe da 2,3 mm
-
Otto viti Pentalobe da 3,0 mm
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel away any stickers from the backside of the rear case covering the feet you have chosen to replace.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove any broken or damaged feet.
-
If the old foot is difficult to remove, use a hair dryer or a heat gun to apply some heat to the area and loosen the adhesive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Scrub the foot cavity with adhesive remover to remove any remaining adhesive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wipe the foot cavity with an isopropyl alcohol prep pad to remove any cleaner residue and prep the area for the adhesive on the new foot.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel a replacement foot from the plastic backing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Align the new foot inside the cavity.
-
Lay the foot down while keeping it properly aligned.
-
Check for proper alignment from the inside of the case. The alignment nub should be slightly visible through the alignment hole.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press the new foot into place firmly with your finger, then apply pressure by pinching the foot from either side of the case with your finger and your thumb.
-
Maintain pressure for 30 seconds to set the pressure-sensitive adhesive.
-
Repeat the last seven steps for any remaining broken or worn feet.
-
Annulla: non ho completato questa guida.
Altre 8 persone hanno completato questa guida.
Un commento
Great kit for replacing the feet on a MacBook. Had a foot fall off my 6 year old MacBook Pro and this kit fit exactly!