Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
The bottom housing holds all your mini's internals.
Cosa ti serve
-
-
Power down your Mac mini, disconnect all of the cables, and flip it over.
-
Insert the Jimmy into the crack between the aluminum top housing and the plastic lower housing.
-
The Jimmy should reach a stop about 3/8" down.
-
-
-
We will first remove the AirPort antenna, located in the lower left corner of this picture.
-
-
-
-
Use the flat end of a spudger to pry the three antenna connectors off the AirPort/Bluetooth combo card.
-
-
-
Use the flat end of a spudger to pry the power button cable connector up off the logic board.
-
-
-
Remove the single Phillips screw between the headphone and microphone jacks on the audio board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.