Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Power down your Mac mini, disconnect all of the cables, and flip it over.
-
Insert the Jimmy into the crack between the aluminum top housing and the plastic lower housing.
-
The Jimmy should reach a stop about 3/8" down.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently bend the Jimmy outwards to pry the crack open a little larger and lift the lower housing up a small amount.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once you have the first side free, rotate the Mac mini and start prying up on the front edge.
-
Use the same prying motion to both bend the clips inward and lift the lower housing up out of the top housing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
You may need to move the Jimmy along the edge to pry up all of the clips. Be patient and do a little bit at a time.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Keep working around the perimeter, freeing the clips along the final edge.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the Mac mini back over and lift the top housing off of the lower housing.
-
-
-
Premere leggermente le due linguette di fissaggio l'una verso l'altra e sollevare l'antenna AirPort dal proprio alloggiamento.
-
-
-
-
Rimuovere l'antenna Bluetooth dal telaio interno premendo entrambi i lati della scheda il più vicino al centro possibile.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the single Phillips screw securing the IR board to the internal frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
De-route the IR board and cable through the channel near the hard drive in the internal frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
De-route the IR board and cable through the channel within the internal frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
De-route the IR board and cable through the small plastic clip in the internal frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use your fingers to disconnect the IR cable connector from its socket on the interconnect board. Make sure to pull straight out, and to pull on the connector and not the cable.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.