Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Sposta l'interruttore di bloccaggio verso destra, nella posizione sbloccata.
-
-
-
Svita cinque viti Torx T10 da 5,1 mm dal perimetro esterno del gruppo della ventola.
-
-
-
Svita le cinque viti Torx T10 da 5,1 mm dal perimetro esterno della copertura inferiore.
-
-
-
-
Usa la parte piatta di uno spudger e un movimento rotatorio per separare delicatamente un lato del connettore dati della scheda grafica.
-
-
-
Gira il Mac Pro a testa in su e appoggialo delicatamente su una superficie piatta.
-
-
-
Usa la parte piatta di uno spudger per scollegare il connettore dell'uscita DC dell'alimentatore dalla sua presa sulla scheda I/O.
-
Usa la punta di uno spudger per scollegare il cavo dati dell'alimentatore dalla sua presa sulla scheda I/O.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 9 mm silver T10 Torx screws securing the IO Board to the IO shield.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the IO board up from the IO shield from the end with the AC plug.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the tip of a spudger to flip the retaining flap on the IO shield ribbon cable ZIF connector.
-
Disconnect the IO shield ribbon cable.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Squeeze and pull the audio jack ribbon cable connector from the IO board.
-
Annulla: non ho completato questa guida.
Altre 5 persone hanno completato questa guida.
3 Commenti
How do you even get the a t10 to fit a such an aggressive angle?
My USB ports don’t work.. I replaced this board and they still don’t work.. Suggestions as to what could be causing this?
I’m having a severe problem with the data cable the runs from the power supply to the IO board. First, I broke a couple of the pins, so I had to order a new IO board. Now the pins are slightly different. Before, they were just sitting out unprotected, but the new board I purchased has a type of barrier around it, but my data cable won’t fit onto the pins now with the new protective barriers. Please help!