Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
The Mac Pro features two 3.5 mm audio jacks: a combined optical digital audio output and analog line out minijack. Use this guide to replace these components.
Before beginning any work on your Mac Pro: Unplug the computer and press and hold the power button for ten seconds to discharge the power supply's capacitors.
Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges.
Cosa ti serve
-
-
Remove five 5.1 mm T10 Torx screws from around the outer perimeter of the fan assembly.
-
-
-
Remove five 5.1 mm T10 Torx screws from the outer perimeter of the lower case.
-
-
-
Use the flat end of a spudger and a twisting motion to gently separate one side of the graphics card data connection.
-
-
-
-
Flip the Mac Pro back over and set it gently on a flat surface.
-
-
-
Use the flat end of a spudger to disconnect the power supply DC-Out connector from its socket on the IO board.
-
Use the tip of a spudger to disconnect the power supply data cable from its socket on the IO board.
-
-
-
Remove the two 9 mm silver T10 Torx screws securing the IO Board to the IO shield.
-
-
-
Remove the three 3.7 mm T4 screws securing the audio jacks to the IO panel.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.