Mac Laptop 2009-2012 Feet Replacement (2009, 2010, 2011, 2012)

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

This is a guide describing how to replace the feet on 2009-2012 MacBook and MacBook Pros. For a full guide including lower case removal, refer to the specific MacBook model's device page.

Cosa ti serve

Passo 1 Feet

Mac Laptop 2009-2012 Feet Replacement, Feet: passo 1, immagine 1 di 3

Mac Laptop 2009-2012 Feet Replacement, Feet: passo 1, immagine 2 di 3

Mac Laptop 2009-2012 Feet Replacement, Feet: passo 1, immagine 3 di 3

Remove any broken or damaged feet.
Remove any pieces from the old foot that may have broken off in the foot hole.
Use tweezers to peel up and remove the old adhesive tape from the foot pad.

Traduci

Passo 2

Scrub the foot pad with adhesive remover to remove any remaining adhesive.

Traduci

Passo 3

Wipe the foot pad with an alcohol prep pad to remove any residue left by the cleaner.

Traduci

Passo 4

Peel a replacement foot from the plastic backing.

Traduci

Passo 5

Mac Laptop 2009-2012 Feet Replacement: passo 5, immagine 3 di 3

Align the new foot inside the foot pad.
Make sure the alignment nub on the foot is lined up with the small hole near the perimeter of the pad.
Lay the foot down while keeping it properly aligned.
Check for proper alignment from the inside of the lower case. Use tweezers to slide the alignment nub so it lines up with the hole.

Traduci

Passo 6

Press the new foot down firmly with your finger and maintain pressure for 30 seconds to set the pressure sensitive adhesive. Support the other side of the cover while you press the foot down.
Repeat the last six steps for any broken or damaged feet.

Traduci