Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Logitech Harmony Smart Control Reset Button Replacement

Cosa ti serve

  1. Logitech Harmony Smart Control Reset Button Replacement, Reset Button: passo 1, immagine 1 di 2 Logitech Harmony Smart Control Reset Button Replacement, Reset Button: passo 1, immagine 2 di 2
    • Using a plastic opening tool, lift up the rubber pad.

    • From the bottom of the device, with your fingers, pull back the rubber pad. This will expose the screw holes.

    • On the bottom of the hub, repeat the step above for the second rubber pad.

  2. Logitech Harmony Smart Control Reset Button Replacement: passo 2, immagine 1 di 2 Logitech Harmony Smart Control Reset Button Replacement: passo 2, immagine 2 di 2
    • With the PH00 bit, remove the four 6mm Phillips screws.

  3. Logitech Harmony Smart Control Reset Button Replacement: passo 3, immagine 1 di 2 Logitech Harmony Smart Control Reset Button Replacement: passo 3, immagine 2 di 2
    • With the plastic opening tool, separate the pieces of plastic from each other

  4. Logitech Harmony Smart Control Reset Button Replacement: passo 4, immagine 1 di 2 Logitech Harmony Smart Control Reset Button Replacement: passo 4, immagine 2 di 2
    • With the PH00 bit, remove the three 4mm Phillips screws.

  5. Logitech Harmony Smart Control Reset Button Replacement: passo 5, immagine 1 di 3 Logitech Harmony Smart Control Reset Button Replacement: passo 5, immagine 2 di 3 Logitech Harmony Smart Control Reset Button Replacement: passo 5, immagine 3 di 3
    • From the yellow corner, pry the circuit board from the housing..

  6. Logitech Harmony Smart Control Reset Button Replacement: passo 6, immagine 1 di 3 Logitech Harmony Smart Control Reset Button Replacement: passo 6, immagine 2 di 3 Logitech Harmony Smart Control Reset Button Replacement: passo 6, immagine 3 di 3
    • Locate the defective reset button.

    • Turn the board around to expose the reset solder.

    • Using soldering iron, remove solder and reset button. Replace reset button and solder.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

IUPUI, Team 3-2, Harley Fall 2015 Membro di IUPUI, Team 3-2, Harley Fall 2015

IUPUI-HARLEY-F15S3G2

4 Membri

5 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 954