Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to lift up one of the rubber pads on the bottom of the hub.
-
Pull back the rubber pad and remove it. This will expose the screws on the bottom of the device.
-
Repeat for the second rubber pad.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a PH00 screwdriver bit to remove the four 6mm Phillips screws on the bottom of the device.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to separate the top and bottom pieces of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the PH00 screwdriver bit to unscrew the three 4mm Phillips screws on the control board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the end of the opening tool under the yellow corner of the circuit board as shown.
-
Gently push upward to pry the board from its housing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Determine which of the five bulbs are defective.
-
Turn the board over to expose the bulb solder.
-
Using a soldering iron, remove the solder and bulb. Replace with a new bulb and re-solder.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.