Logitech Harmony Smart Control Hub Light Bulb Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

Learn how to disassemble the Logitech Harmony Smart Control hub, remove a burned out or defective light bulb or bulb(s), and replace it with new one(s).

This repair requires soldering. View the soldering guide at:

Soldering Guide

Cosa ti serve

Passo 1 Light Bulb

Logitech Harmony Smart Control Hub Light Bulb Replacement, Light Bulb: passo 1, immagine 1 di 2

Logitech Harmony Smart Control Hub Light Bulb Replacement, Light Bulb: passo 1, immagine 2 di 2

Use a spudger to lift up one of the rubber pads on the bottom of the hub.
Pull back the rubber pad and remove it. This will expose the screws on the bottom of the device.
Repeat for the second rubber pad.

Traduci

Passo 2

Use a PH00 screwdriver bit to remove the four 6mm Phillips screws on the bottom of the device.

Traduci

Passo 3

Use a spudger to separate the top and bottom pieces of the device.

Traduci

Passo 4

Use the PH00 screwdriver bit to unscrew the three 4mm Phillips screws on the control board.

Traduci

Passo 5

Place the end of the opening tool under the yellow corner of the circuit board as shown.
Gently push upward to pry the board from its housing.

Traduci

Passo 6

Logitech Harmony Smart Control Hub Light Bulb Replacement: passo 6, immagine 3 di 3

Determine which of the five bulbs are defective.
Turn the board over to expose the bulb solder.
Using a soldering iron, remove the solder and bulb. Replace with a new bulb and re-solder.