Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the plastic opening tool to lift up the rubber pad.
-
With your fingers, pull back the rubber pad. This will expose the screw holes on the bottom of the device.
-
Repeat the step above for the second rubber pad on the bottom of the hub.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the PH00 bit, remove the four 6mm Phillips screws
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the plastic opening tool to pry open and separate the pieces of plastic from each other.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the PH00 bit, remove the three 4mm Phillips screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Starting at the yellow corner, use a plastic opening tool to pry the circuit board from the housing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the defective charging port.
-
Turn the circuit board over to expose the charging solder.
-
Using a soldering iron, remove the solder and the charging port. Install a new charging port and solder.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.