Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the batteries from the mouse.
-
Use a plastic opening tool to peel up the four mouse feet.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five 5.5mm Phillips #00 screws found underneath the mouse feet.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the top of the mouse off of the bottom half.
-
Unplug the programmable buttons from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the black pin that holds the scroll wheel to the motherboard.
-
The protrusion on the bottom side of the pin clicks into the dimple on the base.
-
I find the easiest way to remove the pin is to use the pointy end of the spudger to push on this end of the pin.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
First, lift the assembly from the back (green arrow), while keeping the front clear plastic part resting on the springs (red circle).
-
Then, while pulling it toward the back very slightly, carefully lift the front part off the springs.
-
The clear front part has a hole that attaches onto a clear nibble just below the bracket (blue arrow in second picture) for the scrollwheel to pivot left and right for the left and right scroll function.
-
Though the pivot point isn't attached too deeply. When reassembling, align the circular marks in the front to the springs, then press the back side down into the holder and it will self align.
-
Remove the springs and keep them safe.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.