Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
It's very common for this cord to fray with continued use. Let's open up this mouse and replace the cord!
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the hidden screw hole behind the Logitech sticker.
-
Puncture the sticker to access the screw.
-
Remove all five Phillips screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With all screws removed, carefully pry the top of the mouse away from the body.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a spudger, lift the ZIF cable guard.
-
Remove the cable from the upper housing. The upper housing can now be set aside.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three Phillips screws to free the weight cartridge holder.
-
Lift the weight cartridge holder from the body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry the pin securing the mouse wheel and housing to the left.
-
Remove the mouse wheel and housing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two parallel screws holding a black piece of plastic to the mouse body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two screws securing the bottom circuit board to the bottom plate of the mouse.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the final two Phillips screws near the top of the mouse holding the circuit boards to the plate.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the circuit boards loose from the bottom plate.
-
You may need to use a spudger to pry the circuit free.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pry on each side of the mouse connector until the cable comes free.
-
Annulla: non ho completato questa guida.
Altre 29 persone hanno completato questa guida.
14 Commenti
Thanks for the guide! Despite being super careful with the springs they managed to flick out when I was screwing the circuit board back in, one was never to be seen again. Thankfully the middle mouse button seems to work fine with just one!