Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two screws from each pedal with a 2.5mm allen wrench.
-
Once these screws are off, take off the front faces on each pedal, they should be very easy to remove.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip over the device. Now remove fourteen 15.8 mm screws from the underside of the pedal assembly with a Phillips #1 screwdriver.
-
When finished, flip over the device again so that it's in its original position.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the top cover of the device from the front, don't completely remove it yet though, because there are still wires connecting both halves. (NEED PICTURE)
-
Behind the left-most pedal, there are two 7.4mm screws attaching a wire to the top cover. Remove these with a Phillips #1 screwdriver and release the wires.
-
Once the wires are no longer connected to the top cover, remove the cover completely.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Simultaneously remove the 10mm screws connecting the pedal to the red piston behind it.
-
Once removed, the piston can rotate free of the pedal.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the piston away from the pedal and remove the top half of it. The spring should now be visible. (NEED PICTURE)
-
Take out the spring, and replace it with a new one.
-
Repeat steps four and five for each pedal that needs a spring replaced.
-
Annulla: non ho completato questa guida.
Altre 9 persone hanno completato questa guida.
6 Commenti
Is it possible to replace / renew the potentiometers used for gas / brake?
I replaced the springs and reassembled in reverse order. However, my wheel will no longer power on. Any idea where I would have lost power? Thank you.
What size is the cluch spring
6cm length
2cm diameter