Salta al contenuto principale

Logitech Extreme 3D Pro Joystick Trigger Replacement

Cosa ti serve

  1. Logitech Extreme 3D Pro Joystick Trigger  Replacement, Disassembly of the handle: passo 1, immagine 1 di 1
    • Remove these three Phillips #1 screws:

    • Two 10mm screws.

    • One 7mm screw.

  2. Logitech Extreme 3D Pro Joystick Trigger  Replacement: passo 2, immagine 1 di 1
    • Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

    • Remove the two 10mm Phillips #1 screws.

  3. Logitech Extreme 3D Pro Joystick Trigger  Replacement: passo 3, immagine 1 di 2 Logitech Extreme 3D Pro Joystick Trigger  Replacement: passo 3, immagine 2 di 2
    • Pull apart the joystick chassis by hand.

    • Release this clip located underneath the hand rest

    • The circuit board will be loose and may fall down.

  4. Logitech Extreme 3D Pro Joystick Trigger  Replacement, Joystick Trigger: passo 4, immagine 1 di 1
    • Remove the plastic trigger from the joystick.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Emanuel Canela

Membro da: 01/25/18

1.297 Reputazione

7 Guide realizzate

Team

USF Tampa, Team S7-G1, Passmore Spring 2018 Membro di USF Tampa, Team S7-G1, Passmore Spring 2018

USFT-PASSMORE-S18S7G1

4 Membri

7 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 1,401