Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Linksys WRT54GS v2 Power Connector Replacement

Cosa ti serve

  1. Linksys WRT54GS v2 Power Connector Replacement, Front Case: passo 1, immagine 1 di 1
    • Turn the router over so that all four of its feet are facing upwards.

  2. Linksys WRT54GS v2 Power Connector Replacement: passo 2, immagine 1 di 1
    • Remove the rubber inserts inside the the two purple feet located on the router's front case.

    • This may be a challenge, so try the following two methods:

    • Use a plastic opening tool. Insert the flat end of the tool into the seam and slowly pry the rubber feet out.

    • Use a metal spudger. Insert the point of the metal spudger directly into the hole of the rubber feet and pry the insert out.

  3. Linksys WRT54GS v2 Power Connector Replacement: passo 3, immagine 1 di 1
    • Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.

  4. Linksys WRT54GS v2 Power Connector Replacement: passo 4, immagine 1 di 1
    • Squeeze the sides of the router's backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.

  5. Linksys WRT54GS v2 Power Connector Replacement, Motherboard: passo 5, immagine 1 di 1
    • Slide the board unit out and up.

  6. Linksys WRT54GS v2 Power Connector Replacement: passo 6, immagine 1 di 1
    • Flip the circuit board over and use a Phillips #2 Screwdriver to remove the 6.9mm screw holding the board to the back case.

    • Slide the back cover out and away from the circuit board.

  7. Linksys WRT54GS v2 Power Connector Replacement, Power Connector: passo 7, immagine 1 di 1
    • Turn the circuit board over and identify the solder connections you will desolder.

    • The connections for the power connector are shown in red.

  8. Linksys WRT54GS v2 Power Connector Replacement: passo 8, immagine 1 di 1
Conclusione

To reassemble your device, follow these instructions in reverse order.

Alex Do

Membro da: 10/12/11

51 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 3-4, Regan Fall 2011 Membro di Cal Poly, Team 3-4, Regan Fall 2011

CPSU-REGAN-F11S3G4

4 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,830