Salta al contenuto principale

Les Paul Wireless Guitar Strummer Replacement

Cosa ti serve

  1. Les Paul Wireless Guitar Strummer Replacement, Les Paul Wireless Guitar Body Teardown: passo 1, immagine 1 di 1
    • Remove batteries

  2. Les Paul Wireless Guitar Strummer Replacement: passo 2, immagine 1 di 2 Les Paul Wireless Guitar Strummer Replacement: passo 2, immagine 2 di 2
    • Remove void warranty sticker

    • The sticker is covering a torx screw

  3. Les Paul Wireless Guitar Strummer Replacement: passo 3, immagine 1 di 3 Les Paul Wireless Guitar Strummer Replacement: passo 3, immagine 2 di 3 Les Paul Wireless Guitar Strummer Replacement: passo 3, immagine 3 di 3
    • Unscrew the 11 screws securing the back of the body using a T10 Torx screwdriver. Each screw is 1 cm long.

    • Push level, this will detach the back of the guitar from the front.

    • Carefully remove the back of the body

    • The battery pack cord is attached to both sides of the guitar, be careful not to tear it apart.

    • The neck connector may be stuck to the back so be sure to detach it before fully pulling

  4. Les Paul Wireless Guitar Strummer Replacement, Strummer: passo 4, immagine 1 di 2 Les Paul Wireless Guitar Strummer Replacement, Strummer: passo 4, immagine 2 di 2
    • Remove the 4 screws from the back of the strum chip using a Phillips PH1 screwdriver. each of these screws are 1.2 cm each.

    • Remove the 4 inner screws, each are 0.8 cm.

    • Make sure that when putting back together, the 4 inner screws line up with the small plastic piece underneath.

  5. Les Paul Wireless Guitar Strummer Replacement: passo 5, immagine 1 di 3 Les Paul Wireless Guitar Strummer Replacement: passo 5, immagine 2 di 3 Les Paul Wireless Guitar Strummer Replacement: passo 5, immagine 3 di 3
    • Remove the two plastic holders on the underside of the chip.

    • Pull out the the plastic piece on each side of the strummer.

    • Lift the strummer out of it's location

  6. Les Paul Wireless Guitar Strummer Replacement: passo 6, immagine 1 di 3 Les Paul Wireless Guitar Strummer Replacement: passo 6, immagine 2 di 3 Les Paul Wireless Guitar Strummer Replacement: passo 6, immagine 3 di 3
    • Take the top black cover off the strummer.

    • Slide the black rod out of the side.

    • Clean if needed.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Chris

Membro da: 10/18/13

881 Reputazione

6 Guide realizzate

4 Commenti

Hi recently bought this controller again and the up strum has stopped functioning. Hoping this will fix it. Thanks

liamiley91 - Replica

Did this fix your issue? Thinking about trying it.

D. Preston Peek -

Same here, i want to it try but want to know if i will be able to do it altough i’m not really good with these kind of work

Sébastien Fortuny - Replica

This guitar don't have star power with up guitar? Where is sensor?

Leandro Loureiro - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 100

Tutti i Tempi: 19,364