Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

  1. Remove the two 3mm screws on the back of the device with the Phillips Screwdriver #00 bit. Remove the 2mm screw with a Phillips #00 bit.
    • Remove the two 3mm screws on the back of the device with the Phillips Screwdriver #00 bit.

    • Remove the 2mm screw with a Phillips #00 bit.

    • Using the blue opening tool or spudger, gently remove the back cover to expose the interior of the tablet.

  2. Remove the three 2mm screws on the back of the left speaker module with the Phillips Screwdriver #00 bit.
    • Remove the three 2mm screws on the back of the left speaker module with the Phillips Screwdriver #00 bit.

    • Remove the ribbon cables connecting the boards to the other electrical components

    • Some of the ribbon cables are secured with clips, simply pry up the clips before sliding them out of the pin connectors.

  3. Gently remove the left speaker module.
    • Gently remove the left speaker module.

    • Replace the old left speaker module with the new left speaker module.

    • Be careful not to damage the ribbon cables on the new left speaker module while reassembling the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Charles Rhode

Membro da: 28/09/2017

546 Reputazione

3 Guide realizzate

Team

USF Tampa, Team S2-G4, Nance Fall 2017 Membro di USF Tampa, Team S2-G4, Nance Fall 2017

USFT-NANCE-F17S2G4

3 Membri

12 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 11

Tutti i Tempi: 1,126