Salta al contenuto principale

Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.

Cosa ti serve

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 1, immagine 1 di 3 : passo 1, immagine 2 di 3 : passo 1, immagine 3 di 3
    • Power off the device before starting.

    • Flip the device over with the hinges facing away from you.

    • Remove seven 5.0 mm Torx T5 screws.

    • Remove three 9.5 mm Torx T5 screws.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 2, immagine 1 di 2 : passo 2, immagine 2 di 2
    • Pry around the edges from one side to another with a plastic opening tool.

    • Do not pry on the side with the hinges because this can break the cover.

    • Lift the case from the front until you feel resistance.

    • Do not keep lifting after you feel resistance, or the bottom cover can break.

    • Pull the cover towards you, away from the hinges.

    • Completely lift off the cover.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 3, immagine 1 di 2 : passo 3, immagine 2 di 2
    • Remove the six 5.2mm Torx T5 screws holding the fan in place.

    • Remove the five 5.0mm Torx T5 screws holding the fan in place.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 4, immagine 1 di 3 : passo 4, immagine 2 di 3 : passo 4, immagine 3 di 3
    • Disconnect the two fan wire connectors.

    • Firmly pull the connector out horizontally away from the socket.

    • Carefully lift the fan up and out.

Linea Traguardo

Altre 6 persone hanno completato questa guida.

Shaina Bagri

Membro da: 01/23/20

447 Reputazione

2 Guide realizzate

Team

Cal Poly, Team S19-G3, White Winter 2020 Membro di Cal Poly, Team S19-G3, White Winter 2020

CPSU-WHITE-W20S19G3

4 Membri

25 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 16

Ultimi 30 Giorni: 70

Tutti i Tempi: 3,525