Introduzione

This guide is for removing the ThinkPad X100e's LCD display and replacing it with a new one.

    • Use a Spudger tool to remove the screw covers on each side of the screen.

    • Be sure not to lose screw covers.

    Aggiungi Commento

  1. Using a magnetic screwdriver fit with a PH0 Bit, unscrew the two screws and carefully set the aside.
    • Using a magnetic screwdriver fit with a PH0 Bit, unscrew the two screws and carefully set the aside.

    Aggiungi Commento

    • Pry open the bezel carefully with the spudger tool.

    • You will want to do this until the frame is completely off.

    Aggiungi Commento

    • Remove all exposed screws and carefully set them aside. There should be 6 visible screws.

    • Be sure to set the screws aside on the magnetic mat.

    Aggiungi Commento

    • Lift the screen up carefully, and remove the screws on both sides of the panel. There should be 4 screws.

    • The other two screws are located in the exact place on the other side.

    • Don't forget to place the screws on the magnetic mat, separate from other screws.

    Aggiungi Commento

    • Remove the connector located at the very top of the screen beside the webcam.

    • To remove the connector, simply pull the connector out.

    Aggiungi Commento

    • Fold the panel over until a strip of black tape is visible.

    • Peel the tape down until you get to the base.

    Aggiungi Commento

    • Peel the piece of transparent tape back.

    • At this point there should be some exposed wires underneath the tape.

    Aggiungi Commento

    • Remove the connector carefully with the spudger tool.

    Aggiungi Commento

    • Remove the black tape fully.

    • Now your device is ready for a new panel.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 14

Tutti i Tempi: 161