Salta al contenuto principale

Introduzione

If the laptop is loud, sounds irregular, and the bottom is hot, use this guide to replace your cooling fan.

  1. Turn off your laptop before you begin.
    • Turn off your laptop before you begin.

  2. Remove the nine 6mm screws circled in the picture using a T5 Torx Screwdriver. Remove the two 10mm screws circled in the picture using the same T5 Torx Screwdriver.
    • Remove the nine 6mm screws circled in the picture using a T5 Torx Screwdriver.

    • Remove the two 10mm screws circled in the picture using the same T5 Torx Screwdriver.

  3. After all of the screws are removed, use the iFixit opening tools to carefully snap the black cover off. After all of the screws are removed, use the iFixit opening tools to carefully snap the black cover off.
    • After all of the screws are removed, use the iFixit opening tools to carefully snap the black cover off.

  4. Remove the three 5mm screws using the T5 Torx Screwdriver. Remove the three 5mm screws using the T5 Torx Screwdriver.
    • Remove the three 5mm screws using the T5 Torx Screwdriver.

  5. Pull black wire and gray wire away from cooling fan clips using the tweezers. Pull black wire and gray wire away from cooling fan clips using the tweezers.
    • Pull black wire and gray wire away from cooling fan clips using the tweezers.

  6. Pull out the cooling fan from where it is attached and pull it up until you see where the wire is attached to the motherboard. Using the iFixit Opening Tools, detach the connector. Pull out the cooling fan from where it is attached and pull it up until you see where the wire is attached to the motherboard. Using the iFixit Opening Tools, detach the connector. Pull out the cooling fan from where it is attached and pull it up until you see where the wire is attached to the motherboard. Using the iFixit Opening Tools, detach the connector.
    • Pull out the cooling fan from where it is attached and pull it up until you see where the wire is attached to the motherboard. Using the iFixit Opening Tools, detach the connector.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Isaiah Vang

Membro da: 04/10/2018

645 Reputazione

6 Guide realizzate

Team

UW Stout, Team S6-G6, Ogden Fall 2018 Membro di UW Stout, Team S6-G6, Ogden Fall 2018

UWSTOUT-OGDEN-F18S6G6

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 7

Tutti i Tempi: 138