Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

  1. Turn  off and unplug the computer.
    • Turn off and unplug the computer.

    • Flip the laptop over so that the back panel is facing upwards.

  2. Remove fourteen 7mm Phillips #00 screws from the back panel. Remove fourteen 7mm Phillips #00 screws from the back panel.
    • Remove fourteen 7mm Phillips #00 screws from the back panel.

  3. Use your fingers or an opening tool to gently remove the back panel from the bottom of the laptop. Lay both sides of the laptop next to each other.
    • Use your fingers or an opening tool to gently remove the back panel from the bottom of the laptop.

    • Lay both sides of the laptop next to each other.

  4. Remove five 7mm Phillips #0 screws from the battery holder. Remove five 7mm Phillips #0 screws from the battery holder.
    • Remove five 7mm Phillips #0 screws from the battery holder.

  5. Pinch the connecting cord with one hand and pry the battery connector with the other hand, while gently pulling the connector straight out and towards the bottom edge of the base. When removing the battery, use care to keep it flat and do not open the battery because it can result in fire or explosion.
    • Pinch the connecting cord with one hand and pry the battery connector with the other hand, while gently pulling the connector straight out and towards the bottom edge of the base.

    • When removing the battery, use care to keep it flat and do not open the battery because it can result in fire or explosion.

  6. Remove five 7mm Phillips #00 screws from the cooling fan. Remove five 7mm Phillips #00 screws from the cooling fan.
    • Remove five 7mm Phillips #00 screws from the cooling fan.

  7. Gently lift the fan assembly out of the laptop. Gently remove the connecting wires from the exterior of the fan by slowly "weaving" the cord  between the ridges of the fan. Gently remove the connecting wires from the exterior of the fan by slowly "weaving" the cord  between the ridges of the fan.
    • Gently lift the fan assembly out of the laptop.

    • Gently remove the connecting wires from the exterior of the fan by slowly "weaving" the cord between the ridges of the fan.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Kristen Gismondi

Membro da: 12/11/2014

44.515 Reputazione

95 Guide realizzate

Team

iFixit Membro di iFixit

Community

133 Membri

14.600 Guide realizzate

Very helpful instructions. However, Step 6 indicates that you should remove 5 screws, but really you only need the 2 on the left that are actually connecting the fan to the system board, the rest are unnecessary. In fact, the machine I replaced this on only had the one screw in the top-left.

Jeff Breuer - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 9

Tutti i Tempi: 185