Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the tablet on its screen and use the opening tool to remove the back cover.
-
With the tool, place slight pressure on the tablet to pry the back panel off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grab the battery and gently lift upwards. This will show a red and black coiled wire.
-
Pull the battery gently until the cord has no slack.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully hold the battery in one hand while your other hand's index finger and thumb grab the two wires nearest to their connection point.
-
Use your fingers to give a firm tug to the black and red wires, but do not yank them hard enough to damage the tablet.
-
Remove the battery from the device.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 4 mm screws from the right side of the housing with the Phillips #00 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the long, L-shaped system board.
-
Remove the ten 2 mm screws securing the system board with a Phillips #00 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the central latch with a large opening tool to expose a gold connector.
-
Gently pull the gold connector using the latch.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull up the L-shaped board to disconnect the two connectors at the top and bottom of the board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grab the camera connection with your index finger thumb.
-
Disconnect the camera by gently pulling on this wire.
-