Salta al contenuto principale

Introduzione

If your computer won't boot and is having hard disk/hard drive reading errors, follow this guide to replace it. The guide shows how to remove the back from the device, unscrew the battery from the device, remove the drive from the dock, and unscrew the drive housing.

Parti

Nessuna parte specificata.

  1. Before you proceed, make sure your computer is turned off and it's not connected to any power source. Before removing the drive, make a backup copy of all the information on it if possible. Never remove the drive while the system is operating or in suspend mode. Place laptop with the bottom facing up. Using a Philip #1 screwdriver unscrew all 13 screws. Gently pry the back out using a plastic opening tool, starting from one of the corners.
    • Before you proceed, make sure your computer is turned off and it's not connected to any power source. Before removing the drive, make a backup copy of all the information on it if possible. Never remove the drive while the system is operating or in suspend mode.

    • Place laptop with the bottom facing up. Using a Philip #1 screwdriver unscrew all 13 screws. Gently pry the back out using a plastic opening tool, starting from one of the corners.

  2. Using a Phillips #1 screwdriver, remove the four (5mm) screws holding the hard drive in place.
    • Using a Phillips #1 screwdriver, remove the four (5mm) screws holding the hard drive in place.

  3. Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now

    Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now
  4. Do not lift hard drive straight up otherwise you might risk breaking the connection port. Gently slide the hard drive away  and out out of the connection port.
    • Do not lift hard drive straight up otherwise you might risk breaking the connection port.

    • Gently slide the hard drive away and out out of the connection port.

  5. Using a Philip #1 screwdriver remove 2 screws from each side, (removing 4 screws in total) holding the hard drive into the housing. Using a Philip #1 screwdriver remove 2 screws from each side, (removing 4 screws in total) holding the hard drive into the housing.
    • Using a Philip #1 screwdriver remove 2 screws from each side, (removing 4 screws in total) holding the hard drive into the housing.

  6. Remove hard drive from housing.
    • Remove hard drive from housing.

Conclusione

To reassemble your device, follow these instructions in reverse order with your new replacement hard drive.

Altre 8 persone hanno completato questa guida.

Saddam Alsinai

Membro da: 18/10/2017

553 Reputazione

4 Guide realizzate

Team

UW Tacoma, Team S3-G4, Liner Fall 2017 Membro di UW Tacoma, Team S3-G4, Liner Fall 2017

UWT-LINER-F17S3G4

4 Membri

4 Guide realizzate

Unplug or remove battery first?

Chris Quirke - Replica

Hard disk size?

Mohamad Mustakim - Replica

you do not need to unplug or remove the battery

Holden Animations! - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 15

Ultimi 7 Giorni: 80

Ultimi 30 Giorni: 311

Tutti i Tempi: 10,749