Introduzione

This requires a Phillips head screwdriver. Be careful not to drop the screws into the rest of the computer.

Parti

Nessuna parte richiesta.

  1. Turn off the computer, unplug all cables, and let it cool down. Lay the computer flat on its screen.
    • Turn off the computer, unplug all cables, and let it cool down. Lay the computer flat on its screen.

    • Make sure that the work surface is flat and has nothing sharp on it.

    Aggiungi Commento

  2. Remove the monitor stand screw in the bottom of the stand, and remove the stand completely.
    • Remove the monitor stand screw in the bottom of the stand, and remove the stand completely.

    Aggiungi Commento

    • Remove the two screws on the bottom of the computer, one on each side.

    Aggiungi Commento

    • Locate the slot on the right side of the computer next to the screw hole. Use a plastic opening tool or spudger to pry off the rear cover. (Don’t be afraid to use a little force.)

    Aggiungi Commento

    • Once it has been separated, lift to remove.

    Aggiungi Commento

    • Remove the four screws that secure the arm stand.

    Aggiungi Commento

    • Lift up to remove the arm stand.

    Aggiungi Commento

    • Remove the three screws that secure the fan.

    Aggiungi Commento

    • Disconnect the fan power cable from the motherboard, and remove the fan.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Jackson Blake

Membro da: 22/01/2018

871 Reputazione

9 Guide realizzate

Team

Cal Poly, Team S16-G3, Banghart Winter 2018 Membro di Cal Poly, Team S16-G3, Banghart Winter 2018

CPSU-BANGHART-W18S16G3

4 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 17

Tutti i Tempi: 144