Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn off the computer.
-
Disconnect the charging cable from the computer.
-
Flip the computer upside down.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the two switches that lock the battery. Push the right-hand switch outward into the "unlocked" position.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push and hold the left hand switch outward in the "unlocked" position, then gently slide the battery away from the computer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the seven 5.3 mm Phillips #1 screws holding the back panel in place.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the back panel off using the highlighted tab. The tab should give you enough leverage to pull the panel off smoothly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The computer should be open with many of the internal components shown. You can now access the hard drive, the RAM, and the keyboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 5.33 mm Phillips #1 screws holding the hard drive in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the hard drive from the computer, grab the black tab attached to the hard drive and pull the tab downwards toward the bottom of the laptop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the four 5.2 mm Phillips #1 screws. There are two on each side of the drive holding it in the drive bay.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the drive out of the bay. If all the screws were removed correctly, it should simply slide out.
-
Annulla: non ho completato questa guida.
Altre 8 persone hanno completato questa guida.
2 Commenti
In step 1, failure to unplug the cable does not result in electric shock. The power supply voltage is too low for such shock to happen to a human, but it can cause electrical damage to the motherboard. It is always a safe procedure to work on any machine unpowered (both power supply and battery disconnected and/or removed).
In step 9, be sure to remember the direction that the original drive was pointing when removing. The new drive must point the same direction.