Strumenti

Parti

Nessuna parte richiesta.

Carefully unscrew the four (4) screws on the bottom of the camera.
  • Carefully unscrew the four (4) screws on the bottom of the camera.

  • Make sure you don't miss the one that's actually in the tripod socket hole.

Aggiungi Commento

Open the back door on the camera by pushing down on the door latch.
  • Open the back door on the camera by pushing down on the door latch.

Aggiungi Commento

  • Apply pressure to the bottom plate and it will pop off.

  • From here, you can replace the bottom plate, or continue on to further steps.

Aggiungi Commento

  • Having opened the camera and removed the bottom plate, unscrew the five screws marked in the picture.

  • The screw marked in blue is a tiny bit harder to find because it's in a crevice. Don't miss it!

Aggiungi Commento

  • Apply pressure until the piece you unscrewed in the last step pops off.

Aggiungi Commento

  • Unscrew the four screws on the back of this piece to the lower-left corner of the lens.

Aggiungi Commento

  • Removing the lens motor cover, you should be left with these four pieces.

Aggiungi Commento

  • Located underneath these four pieces is the lens motor.

Aggiungi Commento

  • Now that you've removed the bottom plate, you can pull apart the front and back covers.

  • Start with the front cover and, by applying pressure (perhaps a lot of pressure), snap off the front cover.

Aggiungi Commento

  • Next, the back cover.

  • Apply pressure to remove the back plate.

  • Be careful of the buttons on the top of the camera falling off, they are small parts and CAN get lost easily.

  • The best way to remove the back is to stick your thumbs on either side of the battery socket and separate from there.

Aggiungi Commento

  • You should now have removed the front and back plates.

Aggiungi Commento

  • Remove the four screws holding on the front panel surrounding the lens.

Aggiungi Commento

  • Remove the three gears under the panel you removed in the last step and the lens motor should be able to be removed.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Zachary

Membro da: 12/04/2011

31 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 18-19, Garner Spring 2011 Membro di Cal Poly, Team 18-19, Garner Spring 2011

CPSU-GARNER-S11S18G19

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 6

Tutti i Tempi: 2,010