Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two plastic screw covers below the inside phone screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew both screws using a Torx T6 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry off the screen front cover with a 3mm flathead screwdriver.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry off the speaker, which is glued onto the front cover, using a small flathead screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unsolder the black and red wires of the speaker from where they are attached to the base of the screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Obtain replacement speaker and solder the new black and red wires back to the base of the screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Apply glue to the back of the speaker and place it back in its original position.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.