Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Find the two thumbnail ridges on the side and top of the phone. One is next to the micro SD slot and the other at the top of the phone
-
Once the ridges are located, use the blue plastic opening tool to pry the back cover away from the rest of the phone.
-
Remove the back cover and set it to the side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery using the blue plastic opening tool.
-
There is a small thumbnail ridge at the top left corner of the battery for ease of removal.
-
Put the battery aside.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the precision screwdriver to remove the 6 screws along the edges of the phone.
-
There are 2 screws at the top in each corner, 2 in the middle on the sides, and 2 in the bottom corners.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the blue plastic opening tool to remove the back frame from the rest of the phone.
-
Pry at the micro SD slot. Push the cover for the SD slot away from the front of the phone and pry the back frame away from the rest of the phone.
-
Pry your way around the entire phone to separate the face from the frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
NOTE: This is the most difficult step.
-
Locate system board (silicone board with all of the circuitry on it). Notice that there is a black piece at the top of the system board (with the camera in it).
-
Use the pry bar to push the 2 black tabs away from the system board (located on the sides of the board). These tabs may snap back onto the board, so attempt to hold them off of the board.
-
Use the pry bar to pry the black piece at the top of the phone (looks to be attached to the system board, but is not).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
NOTE: Do not damage the thin wires attaching the motherboard to the speakers
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
NOTE: Remove with caution.
-
(It looks like a thin piece of plastic)
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The camera is held on by 1 sticker on the top of the camera.
-
Remove this sticker using your fingernail.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place new camera in the same location, and place the sticker back on its side.
-
4 Commenti
First, clean the cookware with water and a mild kitchen soap to remove anything that might be on the surface. Rinse with hot water. I do uk.bestessays.com and Then coat the entire bottom of the pan in vegetable oil in this case, canola oil and turn it over onto a paper towel for 10 minutes.
Offer massages in my sanctuary or in the comfort of your own home
<a href="https://thecarriagehousesanctuary.square...">Top Massage Therapist in Westchester County NY</a>
Offer massages in my sanctuary or in the comfort of your own home
Offer massages in my sanctuary or in the comfort of your own home <a href="https://thecarriagehousesanctuary.square...">Best Massage Therapist in Westchester County NY</a>