Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back cover by sliding the tab away from the phone using one finger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift one side of the battery using a plastic opening tool or your fingers.
-
Carefully remove the battery and set it aside.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the nine 4 mm screws from the back cover with a Phillips #0 screwdriver.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert the tip of the iFixit opening tool into the small notch on the side of the case.
-
Slide the opening tool along the seam and around the edge of the phone to separate the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Hold the phone casing with one hand and the keypad assembly with the other.
-
Separate the phone casing from the keypad/motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the two boards apart to separate the keypad from the motherboard.
-
Un commento
When I separated the two halves a small brass piece came out and your instructions do not show nor mention what this is or where it goes. Not even a caution about it coming out upon separation of the halves. It appears to belong on one of the screw posts and because it is brass I believe it is supposed to complete a circuit.