Salta al contenuto principale

Introduzione

Steps to remove LG VX8550 keypad housing

  1. Slide the battery release up.
    • Slide the battery release up.

  2. Remove the battery by lifting away from the case.
    • Remove the battery by lifting away from the case.

  3. Remove the 2 screw covers next to the rear speaker with a Push Pin.
    • Remove the 2 screw covers next to the rear speaker with a Push Pin.

  4. Remove the 4 cover screws with a Philips #00 screwdriver.
    • Remove the 4 cover screws with a Philips #00 screwdriver.

  5. Use the iPod opening tool to pry off the back casing.
    • Use the iPod opening tool to pry off the back casing.

  6. Batterie per PC portatili

    Batteries for all the top PC brands, backed by our Quality Guarantee.

    Acquista ora

    Batterie per PC portatili

    Batteries for all the top PC brands, backed by our Quality Guarantee.

    Acquista ora
  7. Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.
    • Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.

  8. Separate the casing halves.
    • Separate the casing halves.

    • Be sure to keep track of the side buttons as they fall out.

  9. Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.
    • Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.

  10. Carefully lift up on the motherboard to see the ribbon cables underneath.
    • Carefully lift up on the motherboard to see the ribbon cables underneath.

    • Use the spudger to carefully disconnect the ribbon cable from the motherboard.

  11. Remove the motherboard from the front casing by lifting straight up.
    • Remove the motherboard from the front casing by lifting straight up.

  12. Lay the phone with the screen facedown.
    • Lay the phone with the screen facedown.

    • The 6 slider screws are visible.

  13. Peel back but don't remove the blue tape to access the 2 center screws.
    • Peel back but don't remove the blue tape to access the 2 center screws.

    • Remove the 6 slider screws with the Phillips #00 screwdriver.

  14. Lift the keypad housing away from the slider.
    • Lift the keypad housing away from the slider.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Nathan Jones

Membro da: 10/04/2010

83 Reputazione

10 Guide realizzate

Team

Cal Poly, Team 34-55, Forte Spring 2010 Membro di Cal Poly, Team 34-55, Forte Spring 2010

CPSU-FORTE-S10S34G55

5 Membri

20 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,844