Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

  1. Press the light grey button in the top-center on the back of the phone. While pressing, slide the battery and cover up. While pressing, slide the battery and cover up.
    • Press the light grey button in the top-center on the back of the phone.

    • While pressing, slide the battery and cover up.

  2. Unscrew the antenna by grasping the base and twisting counterclockwise.
    • Unscrew the antenna by grasping the base and twisting counterclockwise.

    • The antenna may separate from a black sleeve during removal. You may need to use tweezers to remove the sleeve. Remove both the antenna and the sleeve and set aside.

  3. Kit per Nintendo Switch

    A quick fix to get back in the game

    Shop Switch Kits

    Kit per Nintendo Switch

    A quick fix to get back in the game

    Shop Switch Kits
  4. The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside. The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside. The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside.
    • The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside.

  5. Use a Torx T6 screwdriver to unscrew the four screws on the back of the phone. The bit size is engraved on the base of the bit head.
    • Use a Torx T6 screwdriver to unscrew the four screws on the back of the phone.

    • The bit size is engraved on the base of the bit head.

  6. With the phone flipped open, wedge the back cover from the faceplate by running the tip of the plastic opening tool around the seam on the back of the phone. Gently pull the two pieces apart to separate, and set the back casing aside. Apply enough force to separate the pieces without cracking the back cover.
    • With the phone flipped open, wedge the back cover from the faceplate by running the tip of the plastic opening tool around the seam on the back of the phone.

    • Gently pull the two pieces apart to separate, and set the back casing aside.

    • Apply enough force to separate the pieces without cracking the back cover.

  7. Lift the motherboard to gain access to the keypad and side buttons beneath.
    • Lift the motherboard to gain access to the keypad and side buttons beneath.

    • The motherboard is attached with a thin ribbon cable at the upper right corner of the case. Be careful not to break the cable.

Conclusione

<b>To reassemble your device, follow these instructions in reverse order.</b>

Nico Chiarito

Membro da: 21/01/2010

22 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 8-47, Regan Winter 2010 Membro di Cal Poly, Team 8-47, Regan Winter 2010

CPSU-REGAN-W10S8G47

5 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 8

Tutti i Tempi: 2,456