Salta al contenuto principale
  1. Push the light gray rectangle in the top-center up. While pushing up grab the sides of the battery and pull out. While pushing up grab the sides of the battery and pull out.
    • Push the light gray rectangle in the top-center up.

    • While pushing up grab the sides of the battery and pull out.

  2. Unscrew the antenna by grasping the base and twisting counterclockwise.
    • Unscrew the antenna by grasping the base and twisting counterclockwise.

    • The antenna may separate from a black sleeve during removal. You may need to use tweezers to remove the sleeve. Remove both the antenna and the sleeve and set aside.

  3. Kit di riparazione per Android

    Un nuovo schermo o una nuova batteria sono ad un kit di distanza.

    Acquista ora

    Kit di riparazione per Android

    Un nuovo schermo o una nuova batteria sono ad un kit di distanza.

    Acquista ora
  4. The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside. The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside. The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside.
    • The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside.

  5. Use a Torx T6 screwdriver to unscrew the four screws on the back of the phone. The bit size is engraved on the base of the bit head.
    • Use a Torx T6 screwdriver to unscrew the four screws on the back of the phone.

    • The bit size is engraved on the base of the bit head.

  6. With the phone flipped open, wedge the back cover from the faceplate by running the tip of the plastic opening tool around the seam on the back of the phone. Gently pull the two pieces apart to separate. Apply enough force to separate the pieces without cracking the back cover.
    • With the phone flipped open, wedge the back cover from the faceplate by running the tip of the plastic opening tool around the seam on the back of the phone.

    • Gently pull the two pieces apart to separate.

    • Apply enough force to separate the pieces without cracking the back cover.

  7. Lift the motherboard to gain access to the keypad and side buttons beneath. The motherboard is attached with a thin ribbon cable at upper right corner of case. Do not break the cable.
    • Lift the motherboard to gain access to the keypad and side buttons beneath.

    • The motherboard is attached with a thin ribbon cable at upper right corner of case. Do not break the cable.

Conclusione

<b>To reassemble your device, follow these instructions in reverse order.</b>

Nico Chiarito

Membro da: 21/01/2010

22 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 8-47, Regan Winter 2010 Membro di Cal Poly, Team 8-47, Regan Winter 2010

CPSU-REGAN-W10S8G47

5 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 2,447