Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place a fingernail in slot at in the bottom edge of the phone.
-
Pull up on the back panel while holding down the rest of the phone steady with your hand.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place a fingernail in the slot at the bottom edge of the battery.
-
Pull the battery out.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the nine frame screws with a JIS #00 screwdriver.
-
Pop the camera button frame off with a spudger. The home button should come off along with the frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to separate the screen from the outer frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The home button cable is attached to both the front and the back of the outer frame with adhesive. Orient the frame so that where the screen would be is facing you. Peel back the black rubber tab covering the wire.
-
Detach the cable from the frame with a plastic opening tool and let hang.
-
Flip the phone over and detach the button sensor part of the cable from the frame with a spudger.
-
Pull the backside cable through the hole when removing the component.
-