Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back cover by inserting a fingernail or opening pick here and disengaging the plastic clips.
-
Lift battery up here
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use fingernails or insert an opening pick into the gap between the digitizer and the midframe and pull the midframe outwards to disengage the plastic clips.
-
Carefully disengage the clips on the bottom as the headphone jack goes through the midframe.
-
Once all the clips have been disengaged, move the midframe outwards and downwards to disengage it from the headphone jack.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Halberd spudger or an opening pick to disconnect the front camera flex from its connector on the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the tip of a Halberd spudger or an opening pick, disconnect the display flex cable from its socket on the motherboard.
-
Starting from the bottom, insert an opening pick between the motherboard and frame and lever apart.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The flex cable and speaker are held in with adhesive. Use heat to soften the adhesive.
-
Carefully insert a Jimmy between the flex cable and the frame and detach the cable from the adhesive.
-
Then use the tip of a metal spudger to continue carefully prying the ear speaker up out of its housing.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.