Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the device so the two bottom screws are shown.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 7mm screws holding the back panel of the phone using the P5 bit and magnetic driver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully use the plastic opening tool to pry the back panel of the phone from the front screen. This will expose the battery and other parts.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Phillips #0 screwdriver to remove the 5mm screw holding the metal bracket that protects the battery's ribbon cable.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully use the plastic opening tool to pry the ribbon cable connecting the battery to the motherboard of the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently raise the battery from its compartment.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the thirteen 5mm screws holding the plastic shield covering the motherboard using the Phillips #00 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully use the plastic opening tool to pry the plastic shield from the motherboard. This will expose the motherboard and ribbon cables for each component.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully use the plastic opening tool to pry the ribbon cable connecting the battery to the motherboard of the phone.
-
Slowly pull the ribbon cable upward releasing the volume buttons from the phone.
-