Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Hold the phone camera-side up and locate the rear cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place a thumb below the camera, apply a little pressure, and slide the cover toward the bottom of the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the plastic opening tool in the small slot below and to the left of the battery.
-
Pry the battery upward to remove it.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the #00 Philips screw driver, unscrew the four 4.5mm screws located around the battery compartment.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wedge the plastic opening tool between the screen and the body of the device, using care to avoid damaging internal components.
-
Gently move the tool around the perimeter of the screen to separate it from the body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the device over so the battery compartment faces up.
-
Press the scroll wheel, located in the upper-left corner, into the device to avoid damage.
-
Gently insert the plastic opening tool into the seam between the frame and front cover to separate the back panel from the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the camera near the upper-left corner and use the metal tweezers to carefully detach the black tab.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully slide the metal tweezers underneath the camera in order to lift it out.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.