Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

LG G3 Screen Replacement

Introduzione

This guide will show you how to replace a damaged screen on your LG G3.

This part includes the fused display, digitizer and support frame, if your replacement part is the glass digitizer and screen alone, without the frame, follow this longer, more complicated digitizer and LCD replacement guide.

Cosa ti serve

  1. LG G3 Screen Replacement, Back Cover: passo 1, immagine 1 di 2 LG G3 Screen Replacement, Back Cover: passo 1, immagine 2 di 2

    • Power off your phone before beginning disassembly.

    • Insert a thumbnail, or a prying tool like a spudger, into the notch at the bottom left of the back cover.

    • Pry the back cover up to separate its plastic clips.

    Traduci

  2. LG G3 Screen Replacement: passo 2, immagine 1 di 2 LG G3 Screen Replacement: passo 2, immagine 2 di 2

    • Lift the back cover to release the rest of the plastic clips and remove it.

    • In case you can't lift the back cover completely, slide your fingernail or your prying tool around the midframe to release the remaining clips.

    • To reinstall the back cover, press it firmly into place until you hear a snap from the plastic clips to form a seamless connection with the rear side of the phone.

    Traduci

  3. LG G3 Screen Replacement, Battery: passo 3, immagine 1 di 2 LG G3 Screen Replacement, Battery: passo 3, immagine 2 di 2

    • Use a fingernail or a prying tool at the marked notch to lever the battery out of its recess.

    Traduci

  4. LG G3 Screen Replacement: passo 4, immagine 1 di 2 LG G3 Screen Replacement: passo 4, immagine 2 di 2

    • Lift the battery out of its recess and remove it.

    Traduci

  6. LG G3 Screen Replacement, Screen: passo 5, immagine 1 di 2 LG G3 Screen Replacement, Screen: passo 5, immagine 2 di 2

    • Remove the 13 Phillips #00 screws found on the back of the phone.

    • The screw circled in red is shorter than the other 12 screws. For an easier time when reassembling the phone, store it separately from the other screws.

    Traduci

  7. LG G3 Screen Replacement: passo 6, immagine 1 di 2 LG G3 Screen Replacement: passo 6, immagine 2 di 2

    • Locate the same gap used in the earlier step

    • Remove the bottom panel by gently lifting using your fingers

    Traduci

  8. LG G3 Screen Replacement: passo 7, immagine 1 di 1

    • Remove the top panel by gently lifting with your finger

    • Do not pull up too forcefully, as there is a risk of the top panel breaking

    Traduci

  9. LG G3 Screen Replacement: passo 8, immagine 1 di 3 LG G3 Screen Replacement: passo 8, immagine 2 di 3 LG G3 Screen Replacement: passo 8, immagine 3 di 3

    • Take the plastic opening tool and gently wedge it under where the ribbon cable is connected

    • Gently lift up to disconnect the ribbon cable

    • Repeat until all four ribbon cables are disconnected

    Traduci

  10. LG G3 Screen Replacement: passo 9, immagine 1 di 2 LG G3 Screen Replacement: passo 9, immagine 2 di 2

    • Remove the motherboard by lifting gently

    • Take care not to damage the ribbon cables if the other components are functional. Damaging them may result in other components not working

    Traduci

  11. LG G3 Screen Replacement: passo 10, immagine 1 di 2 LG G3 Screen Replacement: passo 10, immagine 2 di 2

    • The following components are kept in place with an adhesive, so it may take some time and effort to get it out

    • Remove the headphone port

    • Remove the vibration motor

    • Remove the rear-facing camera

    • Remove the earpiece speaker

    • If you are going to be using a screen assembly with a pre-installed frame, you may stop here and follow the previous steps in reverse with your new screen assembly. Otherwise, you will now transfer the LCD bezel as well as the speaker grille.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 129 persone hanno completato questa guida.

Autore

con 14 altri collaboratori

Naoto

Membro da: 10/16/14

4.763 Reputazione

4 Guide realizzate

Distintivi: 17

+14 altri distintivi

Team

UMass Dartmouth, Team 1-3, Duarte Fall 2014 Membro di UMass Dartmouth, Team 1-3, Duarte Fall 2014

UMASSD-DUARTE-F14S1G3

4 Membri

10 Guide realizzate

42 Commenti

Ok so after I did all this my screen is black and so I ordered a second screen and also nothing the phone works great and makes noises also touch responds but nothing on lcd just black can you help me with this also if I take battery out and plug up charger it shows a battery warning on lcd so clearly it works

cabinlife27030 - Replica

Has it sustained any water damage?

Josiah Leas -

Did you get it working i have the same issue? the picture displays with the original screen but not with the new one. i have tried 3 different screens and get the same on all of them. i even tried updating to the latest software but only get a black screen, no picture.

When i have had this on iphones i just so a reset by holding down the buttons and the screen starts to work.

Please someone help

Matt -

Same here! I also findout that lcd still works, if you get some flashlight on screen in a dark room, you will see that only backlight not working when battery plugged. I tried to baking it but it still didn't worked. It's obvious that backlight could properly operate as it works when you take off the battery. I'm looking for solutions, if I find any, will wrote it here.

tufekcisencer -

Did someone find a solution to this? I also replaced my screen and it keeps black solid when I turn it on, even with the touch working properly.

fsnaderfb -

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 36

Tutti i Tempi: 248,639