LG G3 Earpiece Replacement Guide

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

Use this guide to replace the earpiece speaker in the LG G3 (D855).

Cosa ti serve

Passo 1 Back Cover

LG G3 Earpiece Replacement Guide, Back Cover: passo 1, immagine 1 di 2

LG G3 Earpiece Replacement Guide, Back Cover: passo 1, immagine 2 di 2

Power off your phone before beginning disassembly.
Insert a thumbnail, or a prying tool like a spudger, into the notch at the bottom left of the back cover.
Pry the back cover up to separate its plastic clips.

Traduci

Passo 2

Lift the back cover to release the rest of the plastic clips and remove it.
In case you can't lift the back cover completely, slide your fingernail or your prying tool around the midframe to release the remaining clips.
To reinstall the back cover, press it firmly into place until you hear a snap from the plastic clips to form a seamless connection with the rear side of the phone.

Traduci

Passo 3 Battery

LG G3 Earpiece Replacement Guide, Battery: passo 3, immagine 1 di 2

LG G3 Earpiece Replacement Guide, Battery: passo 3, immagine 2 di 2

Use a fingernail or a prying tool at the marked notch to lever the battery out of its recess.

Traduci

Passo 4

Lift the battery out of its recess and remove it.

Traduci

Passo 5 Loudspeaker

LG G3 Earpiece Replacement Guide, Loudspeaker: passo 5, immagine 1 di 1

Remove the four Phillips #00 screws (4 mm length).

Traduci

Passo 6

Insert a thumbnail, or a prying tool like a spudger, into the notch at the bottom left of the back cover you used earlier to remove the back cover.
Pry up the plastic panel, including the loudspeaker, until you can get a good grip.

Traduci

Passo 7

LG G3 Earpiece Replacement Guide: passo 7, immagine 3 di 3

Carefully remove the plastic panel including the loudspeaker by gently pulling it away from the phone assembly.

Traduci

Passo 8 Motherboard Cover Assembly

LG G3 Earpiece Replacement Guide, Motherboard Cover Assembly: passo 8, immagine 1 di 1

Remove the eight Phillips #00 screws (4 mm length).

Traduci

Passo 9

LG G3 Earpiece Replacement Guide: passo 9, immagine 3 di 3

Insert an opening pick between the bottom right corner of the motherboard cover and the motherboard.
Pry up the motherboard cover to open the plastic clips which hold the cover in its place.
The clips can be a bit resistive. If you're having trouble prying up the motherboard cover, slightly rotate the opening pick sideways to make the process easier.
Work your way along the right edge.

Traduci

Passo 10

LG G3 Earpiece Replacement Guide: passo 10, immagine 3 di 3

Carefully lift the right edge of the motherboard cover.
The remaining plastic clips should open during this process or can be unhinged easily by hand.
Remove the motherboard assembly.

Traduci

Passo 11 Motherboard

LG G3 Earpiece Replacement Guide, Motherboard: passo 11, immagine 1 di 2

LG G3 Earpiece Replacement Guide, Motherboard: passo 11, immagine 2 di 2

Use a spudger to pry up and disconnect the display flex cable.

Traduci

Passo 12

Use a spudger to pry up and disconnect the digitizer flex cable.

Traduci

Passo 13

Use a spudger to pry up and disconnect the rear camera flex cable.

Traduci

Passo 14

Use a spudger to pry up and disconnect the front camera flex cable.

Traduci

Passo 15

During these next few steps, make sure to avoid damaging the flex cables you disconnected.
Slide an opening pick under the bottom right corner of the motherboard and slowly pry it out of its recess by rotating the opening pick sideways.

Traduci

Passo 16

Slide the opening pick under the right edge of the motherboard where the SIM card slot is located and pry it up by rotating the opening pick sideways.

Traduci

Passo 17

Grab the top section of the motherboard and carefully lift it out of the phone.

Traduci

Passo 18 Earpiece speaker

LG G3 Earpiece Replacement Guide, Earpiece speaker: passo 18, immagine 1 di 2

LG G3 Earpiece Replacement Guide, Earpiece speaker: passo 18, immagine 2 di 2

During removal of the earpiece speaker, remove it together with the foam gasket underneath.
Use a pair of tweezers to remove the earpiece speaker.

Traduci

Conclusione

If possible, turn on your device and test your repair before installing new adhesive and resealing.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers Community for help.