Salta al contenuto principale

Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.

Cosa ti serve

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 1, immagine 1 di 1
    • Remove the cover of the SD card. Find it on the right side of the back of the tablet.

    • Press the SD card in to make it pop out.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 2, immagine 1 di 1
    • Slide the stylus out from the bottom left corner of the back panel.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 3, immagine 1 di 1
    • Start at a corner and pry the screen up with a plastic opening tool.

    • You can also use a plastic spudger for this task, but do not use metal tools. They can be dangerous to you and the device.

    • Slide the tool in the seam at the edge of the screen.

    • Wedge additional plastic opening tools in the seam to help lift the screen.

    • Slide both wedged plastic opening tools towards the bottom to pop the screen loose.

    • If your screen is cracked, work slowly to avoid flinging glass shards when prying.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 4, immagine 1 di 3 : passo 4, immagine 2 di 3 : passo 4, immagine 3 di 3
    • With a Phillips #000 screwdriver, unscrew the six 4.0 mm screws that hold down the battery.

    • With the Phillips #000 screwdriver, unscrew the two 4.0 mm screws that hold down the battery ribbon connector.

    • Use a magnetic mat to keep track of these tiny screws for later reassembly.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 5, immagine 1 di 1
    • Lift the battery ribbon connector with your finger.

  6. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 6, immagine 1 di 1
    • Lift the battery with your fingers and remove it from the device.

  7. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 7, immagine 1 di 1
    • With a Phillips #000 screwdriver, unscrew the one 4.0 mm screw that is holding down the speaker.

    • Use the magnetic mat to keep track of the tiny screw(s).

  8. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 8, immagine 1 di 1
    • Lift and remove the speaker with your finger.

  9. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 9, immagine 1 di 2 : passo 9, immagine 2 di 2
    • With the Phillips #000 screwdriver, unscrew the four 4.0 mm screw that are holding down the motherboard.

  10. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 10, immagine 1 di 2 : passo 10, immagine 2 di 2
    • Use a plastic opening tool to lift up the ribbon connector at the bottom of the motherboard.

    • Only lift up the end of the ribbon connector that is attached to the motherboard. The end at the base of the tablet should stay attached.

  11. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 11, immagine 1 di 3 : passo 11, immagine 2 di 3 : passo 11, immagine 3 di 3
    • Lift and release the remaining ribbon connectors in the upper left corner of the motherboard with a plastic opening tool.

    • Avoid bending the tips of the ribbon connectors to prevent damage.

  12. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 12, immagine 1 di 2 : passo 12, immagine 2 di 2
    • With your fingers, lift up the motherboard from the upper right corner.

    • Carefully remove the fragile motherboard from the device.

  13. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 13, immagine 1 di 1
    • Insert the plastic opening tool under the ribbon connector that is holding the rear-facing camera down and lift it up.

  14. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 14, immagine 1 di 2 : passo 14, immagine 2 di 2
    • After prying ribbon connector, the rear-facing camera should be ready for removal.

    • Gently lift the rear-facing camera with your fingers and remove.

Linea Traguardo

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 92