LG EnV VX9900 LCD Screen Replacement

Stephanie Villavicencio e 5 altri collaboratori

Ultimo aggiornamento il January 17, 2018

10 - 15 minuti

Moderato

Introduzione

Vai al passo 1

For an easier time working with the LCD Screen, follow the Installation Guide for the Circuit Board and Full Key Board.

Cosa ti serve

Strumenti

Mostra di più…

iFixit guadagna commissioni quando acquisti tramite questi link.

Passo 1 Battery

LG EnV VX9900 LCD Screen Replacement, Battery: passo 1, immagine 1 di 1

Place the phone so the screen side is facing down.
Locate the latch at the end of the phone, opposite of the camera.

Modifica

Passo 2

Push/pull the latch away from the camera, causing the battery to pop out.

Modifica

Passo 3

Remove the battery.

Modifica

Passo 4 Circuit Board and Full Key Board

LG EnV VX9900 LCD Screen Replacement, Circuit Board and Full Key Board: passo 4, immagine 1 di 2

LG EnV VX9900 LCD Screen Replacement, Circuit Board and Full Key Board: passo 4, immagine 2 di 2

Remove the 5 screw covers on the back of the phone using a Push Pin.

Modifica

Passo 5

With a Phillips #00 Screwdriver, remove the five 3.44 mm screws that were under the screw covers.
Also with a Phillips #00 Screwdriver, remove the screw that was revealed once the battery was removed.

Modifica

Passo 6

Open the phone.

Modifica

Passo 7

Starting at the card slot or charger port for greater ease, pry off the colored casing from the back of the phone using the Plastic Pry Tool (or a finger nail may work).
Prying open the part just to the left of the right hinge can be difficult.
Remove the back colored casing and set it to the side.

Modifica

Passo 8

Gently pry and detach the connection located near the hinge with fingers.

Modifica

Passo 9

The circuit board and the key board will be attached, as shown in the second picture.
Lift them both out from the rest of the phone.
Do not try to the detach key board pad from the circuit board. They are replaced as a unit.

Modifica

Passo 10 LCD Screen

LG EnV VX9900 LCD Screen Replacement, LCD Screen: passo 10, immagine 1 di 1

After removing the circuit board and key board, separate the top part with the screen from the bottom part by detaching the hinges.

Modifica

Passo 11

Careful! The paint is easy to scratch.
Remove the 4 screw covers from top piece of phone by using a Push Pin.

Modifica

Passo 12

Remove the four 3.44 mm screws that were under the covers using a Phillips #00 Screwdriver.

Modifica

Passo 13

LG EnV VX9900 LCD Screen Replacement: passo 13, immagine 3 di 3

Be careful while breaking the adhesive connecting the speaker and the casing in the following sub step so that you do not tear any wires.
Pry open the colored casing using the Plastic Pry Tool.
Remove the number pad and place it to the side.