Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Find a sliding button on the lower back side of the device and with your finger, slide it to the left firmly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #00 screwdriver to unscrew the four Phillips #00 screws on the four corners under the battery to unfasten the back case from the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take the case off by using a plastic opening tool.
-
Continue using the plastic opening tool around the sides of the device, unhooking the eight tabs securing the back cover to the rest of the phone as shown in the second photo.
-
The back speaker will be connected to the motherboard, and must be disconnected to remove the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the 4 Phillips 00 screws that connect the two halves of the phone together.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Between the two halves is a ribbon. Use a plastic opening tool to flip up the lock and disconnect it.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry off the plastic tabs that cover two screws, as shown in the first picture.
-
Then, remove the 6 Phillips 00 screws from the back of the case, as shown in the second picture.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry off the back cover from the front of the case using a plastic opening tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry the front speaker and wireless receiver out of the front case using a spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Starting with the side that has the speaker and receiver, carefully lift the LCD Board out of the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unhook the ribbon cable using that flat side of a spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Next, carefully remove the tape from the LCD board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Finally, flip up the black switch to unhook the LCD screen from the LCD board using a spudger.
-
The LCD Board in now accessible.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a flat head screwdriver, pry the plastic covering off of the back of the keypad
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Push the keypad from behind to disconnect it from the case.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.