1. Use a Spudger to remove the two front plastic covers to reveal screws.
    • Use a Spudger to remove the two front plastic covers to reveal screws.

  2. Remove two screws using a Torx T6 screwdriver.
    • Remove two screws using a Torx T6 screwdriver.

    • Pry off the screen front cover with a small flathead screwdriver.

    • Insert a small flathead screwdriver into the hinge and separate hinge connection.

    • Pry off the speaker which is glued on to the front cover using a small flathead screwdriver.

    • Remove remaining portion of the front case from the flexible circuit board.

    • Do not attempt to remove the LCD board at this time, as it is attached to the rear panel assembly.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 3-25, Regan Fall 2010 Membro di Cal Poly, Team 3-25, Regan Fall 2010

CPSU-REGAN-F10S3G25

4 Membri

14 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 893